公司新聞
濟南裝載機的作業操作規定
來源：http://m.66975.cn/ 日期：2022-05-16
作業環境
Working environment
1、裝載機不得在傾斜度超過規定的場地作業，作業區域內不得有障礙物和無關人員。
1. The loader shall not operate on the site with an inclination exceeding the specified, and there shall be no obstacles and irrelevant personnel in the operation area.
2、裝載機的運輸距離不宜過大，行駛道路要平坦。在石材工地作業時，裝載機應在輪胎上安裝保護鏈或使用帶直邊輪胎的鋼鏈板。
2. The transportation distance of the loader should not be too large, and the driving road should be flat. When working on the site, the tire protection belt shall be installed on the steel belt of the stone loader.
3、運行前的檢查和啟動
3. Inspection and startup before operation
4、作業前應檢查液壓系統無泄漏，液壓油箱油量充足，輪胎氣壓符合規定，制動靈敏可靠。
4. Before operation, check that the hydraulic system has no leakage, the hydraulic oil tank has sufficient oil, the tire pressure meets the regulations, and the braking is sensitive and reliable.
作業中的安全注意事項
Safety precautions during operation
1、啟動前應發出聲音，將鏟斗抬離地面約0.5m。作業時應使用低速檔，高速行駛時不要提升和轉動鏟斗。桶內嚴禁載人。
1. Before starting, make a sound and lift the bucket about 0.5m off the ground. The low gear shall be used during operation, and the bucket shall not be lifted and rotated when driving at high speed. It is forbidden to carry people in the barrel.
2、裝積沙時，應低速插入鏟斗，逐漸提高內燃機轉速向前移動。
2. When loading sand, insert the bucket at low speed, gradually increase the speed of the internal combustion engine and move forward.
3、在松散不平的場地作業時，可將鏟臂置于浮動位置，使鏟斗平衡向前推進。
3. When working on loose and uneven ground, the shovel arm can be placed in the floating position to make the bucket move forward in balance.
4、裝載時，鏟斗應從前面插入，以防止鏟斗一側受力。
4. When loading, the bucket should be inserted from the front to prevent stress on one side of the bucket.
5、卸到運輸車上時，要慢，向前和返回時鏟斗不能與車箱相撞。
5. When unloading onto the transport vehicle, it shall be slow. The bucket shall not collide with the vehicle body when moving forward and returning.
6、鏟臂上下移動到最大時，應迅速將操縱桿回位至中位，防止在安全閥作用下產生噪音和誤動作。
6. When the shovel arm moves up and down to the maximum, quickly return the control lever to the middle position to prevent noise and misoperation under the action of the safety valve.
7、時刻注意各種儀表和指示信號的作業情況，聽聽內燃機等部位的運轉聲。如發現異常，應立即停車檢查。只有在故障排除后才能繼續作業。
7. Always pay attention to the operation of various instruments and indication signals, and listen to the running sound of internal combustion engine and other parts. In case of any abnormality, stop the machine immediately for inspection. Work can only be continued after troubleshooting.
8、裝載機臂架升起后進行潤滑和調整時，必須安裝安全銷或采取其他措施，防止臂架墜落傷人。
8. When lubricating and adjusting the loader boom after lifting, safety pins must be installed or other measures must be taken to prevent the boom from falling and hurting people.
9、裝載機工作過程中，應注意隨時清除輪胎（或履帶）間夾雜的碎石。
9. During the working process of the loader, pay attention to remove the gravel mixed between the tires (or tracks) at any time.
10、裝載機及工作場所夜間工作時應有良好的照明。
10. Loaders and workplaces shall have good lighting when working at night.
11、剎車、喇叭、轉向機應齊全、靈敏，行車時必須遵守：“交通規則”。 如果需要經常上路行駛，司機必須持有“機動車駕駛證”。
11. The brake, horn and steering gear shall be complete and sensitive, and the "traffic rules" must be observed when driving. If it is necessary to drive on the road frequently, the driver must hold a "motor vehicle driver's license".
作業后安全注意事項
Safety precautions after operation
濟南裝載機租賃廠家在此提醒您，在裝載機的作業結束后，鏟斗應平放在地面上，操縱桿置于空檔位置，并拉緊手動剎車。更多相關信息的了解就來網站m.66975.cn看看吧。
Jinan loader rental manufacturer reminds you that after the operation of the loader, the bucket should be placed flat on the ground, the control lever should be placed in the neutral position, and the manual brake should be tightened. For more information, please visit m.66975.cn Check it out. Www. 68mn.
公司地址：濟南市商河縣賈莊鎮民營經濟創業園
公司名稱:永誠廣建公路材料（山東）有限公司 
備案號：